Printing With Supports, Good Bed Adhesion And More!..

Perfect First Layer Podcast

We are here to answer and discuss your questions! Please go to our submit page at perfectfirstlayer.com and ask us anything 3D Printer related!

Here are the questions from our listeners this episode:

Hey guys. Just found your podcast and binged the first episodes and really enjoyed them! I do have a question for you. I am having an awful time with supports. I cringe every time I need to use them. I have a Biqu B1 printer and use Cura to slice with. No matter what I do, in the settings, they are hard to remove and end up leaving a lot of marks behind. Any tips you can give me? Thanks again for the great podcast, Jeremy from Oklahoma.

I have a question for you. I recently purchased an Elegoo Neptune 3 PLus and am really loving using it and 3d printing! I have tried a couple large prints on it and am having issues with the models sticking to the bed while printing. It always seems to happen when the print is almost through a 20 hour + print and it gets ruined. I am using Matterhackers PLA and using the recommended settings for both the hot end and the heated bed. What am I missing? Steven.